Bossarea Forum
Bossarea Forum
Home | Profile | Register | Serial Database | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Boss Products
 Boss Compact Pedals
 Grommets: Where do I get 'em?
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

ampman72
Copper Member

USA
3 Posts

Posted - 03/19/2007 :  22:18:28  Show Profile  Visit ampman72's Homepage  Reply with Quote
Nearly all of my beloved made in japan pedals ('83 SD-1, '87 CE-2, '88 DM-3, '87 NF-1 and '80 SG-1) have a deteriorated grommet that goes around the pedal screw. The grommets became melted and distorted, offering little or no protection to the screw slot.

Do any of you guys have a source for these grommets? I would like to get a dozen or so. Thanks in advance.


Edited by - ampman72 on 03/20/2007 05:23:22

bossarea
Forum Admin

United Kingdom
3652 Posts

Posted - 03/19/2007 :  22:40:15  Show Profile  Visit bossarea's Homepage  Reply with Quote
There's an old thread here about this problem.
http://www.bossarea.com/forum/topic.asp?TOPIC_ID=93

For best fit you will probably have to contact Roland but some close replacements can be found.
Go to Top of Page

ampman72
Copper Member

USA
3 Posts

Posted - 03/20/2007 :  05:22:24  Show Profile  Visit ampman72's Homepage  Reply with Quote
Thank you sir.
Go to Top of Page

whurly
Copper Member

Australia
37 Posts

Posted - 03/20/2007 :  11:01:20  Show Profile  Reply with Quote
I'd be interested to see if you get a reply because I've contacted Roland Australia regarding grommets and screws and I've heard nothing.
Go to Top of Page

guirat
Silver Member

United Kingdom
186 Posts

Posted - 03/21/2007 :  02:02:55  Show Profile  Reply with Quote
They should have a Paypal-enabled site where you can just fill a cart with spares. It's possibly a lot of hassle for them to reply personally regarding such low cost parts, though I think there's a minimum order charge which I was quite prepared to pay. I haven't heard back either (UK site). I looked at the rubber grommets in Maplins, but they aren't the correct internal diameter. Are they made specifically for pedals, or are they a standard size used in electronics/engineering in general? I read a post (I'm sure on here) where someone tracked down similar in a hardware store, though it was in the US. I'll keep looking too.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Bossarea Forum © 2005-2007 BossArea Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.06